Millwork / Furniture - Nitrocellulose Lacquer Systems - Gloss Black Lacquer Finish

  • Product Description
  • Physical Properties
  • Application Data
  • Directions for Use
  • Technical Literature

Product Code:

1A13

Product Description and Uses:

Schwartz 1A13 Gloss Black Lacquer is a fast-dry, bodied nitrocellulose-based black lacquer for both interior wood and metal.

It can be used as topcoat for surfaces primed with 1A4 Black Ground Coat.

Product Advantages:

  1. Fast dry.
  2. Excellent build and adhesion.
  3. Excellent flow and leveling.
  4. High solids.

Standard Container Sizes

205L Drum

18.9 Litre Pail

Physical Properties:

Viscosity:

1700 - 2200 cps

Flash Point:

5°C

Weight Solids:

23.3 %

Density:

0.935 g/ml

Sheen:

85

Appearance

black liquid

Shelf Life:

2 years unopened

Environmental Information:

VOC: max 704 g/L

Suggested Uses:

Used as finish coat for interior wood and metal.

Mixing Instructions:

Mix before use.

Reduce with 30% 4T100 Lacquer Thinner to adjust spray viscosity.

Recommended System:

For a smoother finish, prime with Schwartz 1A4 Black Ground Coat followed by Schwartz 1A13 Gloss Black Lacquer.

Application Tools:

Apply using conventional, airless, air-assisted airless and HVLP sprayer/atomizer.

Coverage:

400 - 50 sq ft/gal (1 mil dry film)

Dry Time:

Tack free in15 minutes (25C, 60% RH).
Dry Hard in 30-45mins. (25C, 60% RH).

Cold temperature and high humidity can cause prolonged dry times.

Recoat time:

30-45 minutes (25C, 60% RH)

Clean-up Solvent:

4T100 Lacquer Thinner

Reducer:

4T100 Lacquer Thinner

Retarder:

4T175 Retarder

Pot Life:

NA

Surface Preparation:

Surfaces must be clean, dry and contaminant-free.

Sand wood with 150-grit sandpaper before coating.

Remove all dust.

When primer/sealer or topcoat is sanded, always apply succeeding coat within 8 hours of sanding.

Sand between coats with 280-320 grit sandpaper.

When used on metal, remove all dirt, grease and contaminants.

Clean metal with 4T100 before finishing.

Application:

Following surface preparation, apply Schwartz 1A4 Black Ground Coat as primer (see TDS for recommended application).

On a properly prepared and/or primed surface, apply 2 even coats of 1A13 Gloss Black Lacquer by spray.

Always allow to dry and scuff sand between coats with 280-320 grit sandpaper.

Ambient Conditions:

Use only when ambient conditions are 18°C to 30°C and RH= 40-60%.

Wood moisture content must be between 6 - 10%.

Substrates should be acclimated with recommended ambient conditions.

Storage:

Store indoor at room temperature, away from heat, ignition sources, open flames and direct sunlight.

Warning:

Avoid sparking, use non-sparking tools.

Avoid open flames, turn off all pilot lights, ensure that work area is properly ventilated.

Soiled rags and waste products may contain combustible liquids or vapours, dispose in accordance with local regulations.

Refer to MSDS for information on safe use of this product.


For SDS and Technical Literature please call or e-mail us at;


Tel: 905-683-0411 | Toll Free: 1-866-519-9674
Email: info@schwartzchem.com