Product Code:

80C70LV

Product Description and Uses:

Schwartz Classic Polyurethane Finishes are modified polyurethane finishes designed for the professional hardwood floor refinisher. Ideal for interior residential wood floor applications.

Product Advantages:

1. Low VOC.

2. Good durability and abrasion resistance.

3. Good flow and leveling.

4. Warm amber finish.

5. Good resistance to common household cleaners.

Physical:

Environmental Information:

VOC: max 350 g/L (CEPA Compliant)

Surface Preparation:

Surface to be coated must be clean, dry and contaminant-free. Follow NOFMA Guidelines for sanding.

Old floors:

Use medium grit (50, 60, 80) sandpaper to remove old finish or wax, and to level the floor.

Depending on the build-up of old finish start with a coarse grit (36, 40 ) sandpaper then move to a medium grit . Finish-off with fine grit (80, 100, 120, 150) sandpaper for final cut.

New floors:

Use medium grit to level floor and finish-off with fine grit sandpaper.

Vacuum and tack with lint-free towel dampened with water or mineral spirits.

Ambient Conditions:

1. Use only when ambient conditions are 18°C to 30°C and RH = 40-60%.
2. Wood moisture content must be between 6 - 10%.

Application:

Use 1C259 or 1C360 Floor sealer to seal surface.

Let dry for 1 hour.

Buff with used 120 grit screen.

Vacuum and tack with lint-free towel dampened with water or mineral spirits and let dry.

Apply first coat of finish with recommended applicator.

Always work with the grain, and start and stop where floor and wall intersect.

Never stop in the middle of a floor.

Do not retouch missed areas if finish has begun to skim over, the next coat will fill these areas.

Allow for a minimum 8 hours dry time. Buff with used120 grit screen or maroon pad.

Vacuum all dust and tack with lint-free towel dampened with water or minneral spirits.

Let dry completely before applying second coat. For heavy traffic areas apply a third coat.

Always buff, vacuum and tack between coats.

Stained Floors:

Apply stain following manufacturer's recommendations.

Allow stain to dry for 24 hours under recommended conditions.

Make sure stain is thoroughly dry prior to applying the finish.

Allow final finish coat to dry for 24 hours before use and avoid heavy traffic for 72 hours.

Do not replace any floor covering such as rugs and mats until finish has been fully cured for 14 days.

Avoid cleaning the floor with water for 2 weeks, use dry cloth only.

Storage:

Store indoor at room temperature, away from heat, ignition sources, open flames and direct sunlight.

Warning:

Avoid sparking, use non-sparking tools.

Avoid open flames, turn off all pilot lights, ensure that work area is properly ventilated.

Soiled rags and waste products may contain combustible liquids or vapours and may SPONTANEOUSLY COMBUST, dispose in accordance with local regulations.

Schwartz Classic Polyurethane wood floor finish is not recommended for gymnasiums. Schwartz Recommends the use of the Premium Polyurethane Gloss Finish for these applications.

Refer to MSDS for information on safe use of this product